Rerurn to Romy the Cat's Site
In the Forum: Horn-Loaded Speakers
In the Thread: Garg wants more horns.
Post Subject: Full quarterPosted by Gargoyle on: 8/25/2024
Functionally speaking I think the printer will be OK for this size of horn. I would thicken up the walls a little bit like the smaller horns, this will make the exterior flare not quite as steep, so that I can print the parts vertically. This would produce a bit nicer joint, as the seam is slightly effected with the piece printed on the side.
Last night I found a thread on here that shows an almost identical horn, conceptually. I don't know if he built it or not but would like to acknowledge that I have seen it and the similarity. Perhaps I have seen it before, perhaps it's just a default thought. (Jessie Dazzel)
Now I am going to look at the next size up, it should still be reasonable practical.
Rerurn to Romy the Cat's Site