Rerurn to Romy the Cat's Site


In the Forum: Horn-Loaded Speakers
In the Thread: Garg wants more horns.
Post Subject: Back to smooth for nowPosted by Gargoyle on: 8/23/2024
I ran into some stability issues the other night, it failed about 80% through due to stability issues. I knew it was quite a risk but I generally like to avoid  support so I keep that in mind when designing and orienting the print.

Since I've added a bit of support I've removed the texture to save on time. (Texture almost doubles the time) The texture would have also caused some minor annoyances with the captive nuts and hardware clearances are guesstimated.
Hopefully be then the software would be updated a bit, it has the option to add texture to all walls or outside walls, the problem is these pieces of horn do not have inside or out. For the small horns I would like the option for "inside" only which is oddly missing. They have a good paint on feature for the support that would be good if they could combine that with the fuzz.

If the shape was simpler I could put some interfering shape that would block the texture, but the horn is too curved and thin it would be difficult. I just print it along the long side now with a bit of support and no texture to save a bit of time, as these first ones are just temporary.


Really I should consider the attachment point for mounting as those would likely take a few attempts to settle on something

Rerurn to Romy the Cat's Site