Rerurn to Romy the Cat's Site

You would not have ‘limitations imposed by of a pair of SET amps such as the ML2s”. ML2 would do fine, juts make sure that it would be older ML2 before 2001-2002 production. You try the Melqs then, the parts are not a problem at all. Everything is very much available not expensive. Theoretically is possible substantially simplifying the Melq. You can use input caps everywhere beside the second stage. Go for smaller last capacitors in filter and combine the positive bias supple with supply of the first stage. If you will be driving down to 40Hz then you might go away with those simplifications with practically no harm to sound. I made the Melq Support Forum available specially for people who wish pursue the amp and I would provide all necessary assistance, including pointing out where to get the approved :-) parts. Everything is really perfectly shippable but be advised that I do not care about the “parts sounding” and voicing amplifiers THAT way. Use any good quietly commercial parts, preferably not “audiophile grade (they are mostly crap) and you would be fine. I am sure that you would be able to get everything you might need right in there…

The caT


PS: the following posts went toward the Milq amplifier and have no relation to the subject of Hiss of S2 driver. Therefore, the thread was spited and the continuation might be found at:

http://www.goodsoundclub.com/TreeItem.aspx?postID=2686

Rerurn to Romy the Cat's Site