Rerurn to Romy the Cat's Site


In the Forum: Melquiades Amplifier
In the Thread: Bias help
Post Subject: Further troubleshootingPosted by G on: 4/5/2018

Thanks for your reply.

I have double checked everything and my VR1 is connected on the positive bias side. With the input shorted I get -4.2V on the grid and it stays the same after I unshort it and adjust VR1 to 0v.  Yesterday voltage was drifting +-10mV with nothing connected at the input but as soon as I connect my preamp it drops to 0V and stays there. So should I be measuring DC with the preamp connected and just ignore the voltage drift when nothing is connected?

The big problem that I have is when I switch the amp off the voltage on the input creeps up to around 55v over 1 minute and then slowly starts dropping down as the last positive power supply cap - C8 starts to discharge. The last negative bias power supply cap C9 discharges quite quickly into R17 but C8 stays charged up. Something is not right. 

What are the R13 & R14 – these should not be connected to ground?

V1 on the schematics is the positive supply gas tube. I guess that the process for measuring the gas tube current draw will be the same. Please let me know if below is correct.

Thanks

Gintaras


gas tube current.JPG

Rerurn to Romy the Cat's Site