Rerurn to Romy the Cat's Site


In the Forum: Melquiades Amplifier
In the Thread: Planning my DSET
Post Subject: Something I observe…Posted by Romy the Cat on: 4/18/2017
There are 3 thing about which I would like to share my view 
 
1) Air vibrations transmitted to the amp. I do understand concerns about vibration transmitted over hard surfaces. The vibrations transmitted over the air? I do not think so. I personally do not buy it.  
 
2) The EM field. I think it is valid. The channels will have a lot of efficiency and at 110dB you need a juts a few mV to hear noise. In case of unpleasant loop is formed the voice coil at 110dB will act as a super sensitive antenna…  
 
3) Location of the last caps. This is VERY important. In the sketches at the last page Anthony show that the last electrolytic caps are located at PS side. This is not good. The last cap much be located as close as possible to the load as the cap is the path where AC will be shorted to ground. You do not want this path to ground to be over the long cable from amp to PS.

Rerurn to Romy the Cat's Site