Rerurn to Romy the Cat's Site


In the Forum: Didital Things
In the Thread: Analog Transfer: the first draft.
Post Subject: The level was fine during recording.Posted by Romy the Cat on: 2/21/2010
fiogf49gjkf0d

 manisandher wrote:
You beat me to it. I was going to post that I've never seen so many red LEDS light up on the Model Two!

This is the whole point of the experiment. I have absolutely no LEDS light during recording on Pacific and I had absolutely no LEDS light on VaweLab during recording. I was running the max analyses on VaweLab during recording and it never hit 0dB. If so, then why the RECORDED FILE went over 0dB?

 manisandher wrote:
Have you tried adjusting the sensitivity of the peak level meters on the Model Two before you record? Could it be that you have the sensitivity set too low, at say 7 samples, i.e. allowing too many samples through before registering a peak? Just a thought...

I guess the adjusting of the sensitivity sets the left boundary of the miter, not the right one. I think 0dB is 0dB at 1dB over a full scale or at 40dB of full scale.

The Cat

Rerurn to Romy the Cat's Site