Rerurn to Romy the Cat's Site
In the Forum: Audio Discussions
In the Thread: Initial thoughts about new/old Lamm ML2s
Post Subject: Actually a Good QuestionPosted by Paul S on: 1/10/2010
fiogf49gjkf0d
Jessie, you just set your DMM to VDC and put the probes in the holes next to V2. Like Romy said, because of the clever arrangement, the reading you get in VDC corresponds directly to what you'd get if you measured mA (if you could actually measure it).
On my amps the original lettering on the amp's decks is still legible. This clearly says .31VDC, and that's just what you want to see on your DMM screen, if you run your amps to "spec". I happen to use 280mA/.28VDC from the points near V2, and 185VDC (instead of the "spec" 175VDC) reading from the holes next to V1.
Paul SRerurn to Romy the Cat's Site