Rerurn to Romy the Cat's Site


In the Forum: Analog Playback
In the Thread: Schroder Tonearms
Post Subject: Schröder SetUpPosted by bernie_f on: 12/16/2009
fiogf49gjkf0d
Hi Romy.
I completely agree with you regarding the VTA <-> VTF relation on every arm out there (the lever rule also seems to work with tonearms ;-)). Also i agree that if you want the correct absolute measurement of VTF you have to do it on the record level. But we should not forget, that any cartridge has a range of VTF that can be applied without damaging the suspension of the needle. So what i do after mounting a Pickup is to set VTF to the middle of the correct/recomended range and then find the sweet spot by listening to the result and changing in small increments. Then i measure again and take this VTF as my personal reference point for that pickup in case of removing and remounting it (listening to the settings is always the best way for setup).
Regarding the relation of applied damping <-> VTF on the Schröders: the damping is applied by changing the distance between the magnet on the base and the magnet on the arm that is hanging from a thin string. The small distance between the two (ca. 0.3mm on average damping) defines the amount of damping that is the result of Foucault currents between the magnets (like the electric brakes on busses or trucks). A change of +/-0.1mm is clearly audible. Bass definiton and the resolution of decays are the things to listen to when adjusting the right ammount (like on conventional arms too). So when you decrease or increase the damping you rise or lower VTA too, but in very, very small margins. Changing the VTA some degrees up or down does almost nothing to damping, since the gap between upper and lower magnet stays the same (because the magnets are in the form of two spoons with a small gap between them).
Antiskating by applying some twist to the string holding the armwand. This is done with the screw on the top of the base. On this Photo you can see the construction in detail: http://www.schroeder-tonarme.de/images/TaDPSsemibackview.JPG
This arms do work really well. But have to be readjusted from time to time. When the avereage room temperature changes or the average air humidity changes (summer<->winter). This is the result of the string changing some parameters. This will be avoided in the future with new string-fabrics i hope...
Thanks Romy for giving us the opportunity to discuss this topics on your fine site...
ciao
bernie from vienna

Rerurn to Romy the Cat's Site